LEKI Khumbu Lite, Makalu Lite, Legacy Lite & Albula Lite Replacement Lower Section

Product code LESECL96 - Black Anodized

£21.75
Item coming soon

Description

LEKI Code: LESECL96 12 mm Lower Section 455 mm Length Black Anodized Speed Lock 1 (SL1) 14/12 mm Section Production Era: 2003–2010
This 12 mm lower section is the standard replacement for a large family of LEKI Speed Lock 1 (SL1) Lite and Ladies trekking poles produced between 2003 and 2010, covering well-known models including the Khumbu Lite, Makalu Lite, Legacy Lite, Albula Lite, Albula Lite V, and Tremalzo. The 12 mm section diameter is smaller than the standard 14 mm used across LEKI’s mainstream trekking range, placing these poles in the reduced-diameter Lite and Ladies geometry built for lighter loads, smaller users, and lower-impact trekking. The SL1 external lever provides fast one-motion height adjustment from 100 to 135 cm, clamping directly against the outer wall of the 12 mm section. The black anodized finish (colour code 033) and the 455 mm printed length are both defining specifications for this version. From steady days across the Cairngorms plateau to well-worn paths through the Brecon Beacons, these poles were trusted companions in the lighter-weight hillwalking bracket for over a decade. When the lower section is bent, cracked, or worn beyond reliable service, this replacement restores the original 12 mm geometry and SL1 function precisely. The section cannot be substituted with a 14 mm version — the lever collar will not seat correctly on a different diameter. Verify both the printed length and the diameter on your existing section before ordering. Sold as a single section.

 

► Full Technical Specifications
LEKI Spare Part Code LESECL96
Article Code 81 05 09 12 0455 33
Section Position Lower — tip end
Section Diameter 12 mm
Printed Length 455 mm — check this on your existing section before ordering
Section Profile 14/12 mm
Material Aluminium
Finish / Colour Code Black Anodized (033)
Locking System Speed Lock 1 (SL1) — external lever
Construction Telescopic (Vario) — 3-section
Production Era Approximately 2003–2010. The 12 mm diameter and 455 mm printed length are specific to this SL1 Lite / Ladies family — verify both on your existing section before ordering.
Sold As Single section
► Compatible Poles & Fitting Guide
This lower section is confirmed compatible with the following LEKI SL1 Lite and Ladies trekking poles. Always verify the printed length and diameter on your existing lower section before ordering.
Khumbu Lite — article code 65221531
Makalu Lite — article codes 65221082, 6492108
Legacy Lite — article code 65221841
Khumbu / Khumbu Lite — article code 6492153
Albula Lite — article code 6402108
Albula Lite V — article code 6403208
Tremalzo — article code 6402188
Additional confirmed compatible article codes (model names not established from available sources): 6322848, 6492232, 6492219, 65128301
Diameter check: This is a 12 mm section. Measure the diameter of your existing lower section with calipers — if it measures 14 mm, this section is not suitable. Only 12 mm SL1 sections are compatible with this lever collar.
Length verification: The 455 mm printed length is the standard for this 12 mm SL1 family — measure the printed marking on your existing section, not the physical length. A section showing any other printed length requires a different spare part.
Fitting: Slide the new lower section into the middle section from the tip end. Close the Speed Lock 1 lever firmly to secure. The lever should close flush with the collar — if it does not close fully or the section moves under load, the lever tension may need adjusting.
Lever tension adjustment: If the section moves under normal lever clamping force, tighten the adjuster nut on the clamp collar clockwise in quarter-turn increments until the lever locks securely. Do not overtighten.
Not sure? Email photos of the full pole, the damaged section, and any visible article codes to [email protected] so the correct replacement can be confirmed before ordering.
► Not Compatible With
SL1 poles with 14 mm lower sections — this is a 12 mm section; the lever collar will not seat correctly on a 14 mm section and the pole will not lock securely
SL1 poles with 561 mm lower sections — this section is 455 mm; the longer 561 mm section used in some 12 mm SL1 variants is a different spare part and not interchangeable
Speed Lock 2 (SL2) poles — later external lever generation with revised interfaces; SL1 sections are not interchangeable with SL2 lever collars
SLS (Super Lock System) poles — internal twist-lock mechanism; entirely different locking interface from the SL1 external lever system
 

 

BEFORE YOU ORDER — FOUR-POINT CHECK
Printed length: Must read 455 mm on your existing lower section — check the printed marking, not a physical measurement
Diameter: Confirm 12 mm lower section diameter — measure with calipers at the widest point of the section. This is a Lite / Ladies 12 mm section, not a standard 14 mm section
Locking system: Confirm Speed Lock 1 (SL1) — the lever opens outward from a hinged collar. If your pole has an SLS internal twist-lock collar or an SL2 lever, this section is not suitable
Construction: 3-section telescopic (Vario) with 14/12 mm section profile — verify the profile matches before ordering
Unsure? Email photos of the full pole, the damaged section, and any visible article codes to [email protected] for confirmation before ordering

Trade Mark of Manufacturer: LEKI

Manufacturer & EU Responsible Person: Leki Lenhart GmbH, Karl-Arnold-Stabe 30, 73230 Kirchheim/Teck, Germany

Contact: www.leki.com

Not in your size?

Fill in your email address and we'll email you when your size is back in stock.